Source material from Richard Henry’s presentation on various ways to finish your carving.

Richard Henry, during his presentation on finishes. See more details about the presentation in the Escondido Woodcarvers newsletter, Fall 2026 issue.
Finishes for carvings
- Natural
- Wax
- Shoe polish in a desired color
- Spray lacquer like Deft (Gloss, Matte, Flat)
- Spray acrylic
Color approaches
Wash carving with Simple green to remove residual hand oils, then dry.
(This approach to cleaning assumes that you have not sanded the carving. Sanding a carving and then wetting the surface results in “raising the grain” of the wood. The raised grain is wood that is not sheared off the surface during a carving process but merely crushed down during the sanding process. Clearly, some of the sanded surface is not crushed, but raised grain is an issue if you need to clean a sanded surface.)
A
Seal with 50/50 methyl alcohol and dewaxxed shellac
One coat with 50/50 gesso and water
Color with acrylic paints thinned to water consistency to show wood underneath
Used multiple coats of color to get the depth of color desired
Topcoat with spray clear lacquer or clear acrylic
Or
B
Soak with Wood conditioner to seal the end grain
Color with oil paints thinned with mineral spirits
Topcoat with spray clear lacquer
Wax finishes are easy to apply and buff. They tend to dull over time and need to be renewed from time to time. This is not a really durable finish if you anticipate your work will be handled.
Acrylic finishes and oil finishes protected with a final coat of lacquer are very durable and keep their appearance and color quite well over time. They take more work to apply but the results can be out standing.
Sanded Oil Finish
Sand your work to 400-grit level.
Leave the sanding dust on the work.
Liberally cover with a drying oil such as Watco Danish Oil, Liburon, Tung Oil, or boiled linseed oil. These oils all dry but the drying time varies between brands.
While the work is wet, rub the surface with wet/dry sandpaper, starting with 400 grit.
Allow the work to sit for a few minutes.
While the work is still wet, wipe the surface until there is only a film of oil on the surface of the work.
Allow the work to dry for 24 to 48 hours.
I repeat the process with 400-grit paper twice with each of the following grits: 600, 800, 1000. 1500. and 2000
You may decide that you like the finish at any particular level. I run this process to the 2000-grit level because I like that appearance. Russ Fillback finished an Appalachian Rocking chair using grits all the way to 20,000. The finish looked like glass.

Leave a Reply